educacion
Wind Turbine
A mini wind turbine project. The blades with rotor were taken, but modified, from larsonmattr's Mini - Wind Turbine. https://www.thingiverse.com/thing:4941 I added a motor holder, tower, and base. All parts are pressure fitted for convenience, except where the top of the tower meets the motor holder, by design I allow the motor holder to rotate with strong winds. If a fixed position is desired, it can be easily modified with some glue. The motor opening is 15.2 mm x 19.8 mm, and rotor will accept a 2 mm shaft diameter. Note: The base is a tight fit. However, with some effort, you should be able to get it locked down with the tower perfectly perpendicular to the base. The two pieces that make up the tower are much easier to connect. Your mileage may vary based on your printer's specs but you may need to adjust the connection slightly. If too big, scotch tape should work to make the fit tighter. If too small, a bit of sanding should work. Update: Bacheporo has graciously modified the rotor hub to allow for clock-wise rotation. http://www.thingiverse.com/thing:1858426
$ 30.000
$ 30.000
Cantidad
1
- Envío gratis a todo Colombia
- Hecho a pedido
- Si llega dañada, la reimprimimos
- Pago 100% seguro · Bold · PSE · Nequi
Características
Sobre esta figura
A mini wind turbine project. The blades with rotor were taken, but modified, from larsonmattr's Mini - Wind Turbine. https://www.thingiverse.com/thing:4941 I added a motor holder, tower, and base. All parts are pressure fitted for convenience, except where the top of the tower meets the motor holder, by design I allow the motor holder to rotate with strong winds. If a fixed position is desired, it can be easily modified with some glue. The motor opening is 15.2 mm x 19.8 mm, and rotor will accept a 2 mm shaft diameter. Note: The base is a tight fit. However, with some effort, you should be able to get it locked down with the tower perfectly perpendicular to the base. The two pieces that make up the tower are much easier to connect. Your mileage may vary based on your printer's specs but you may need to adjust the connection slightly. If too big, scotch tape should work to make the fit tighter. If too small, a bit of sanding should work. Update: Bacheporo has graciously modified the rotor hub to allow for clock-wise rotation. http://www.thingiverse.com/thing:1858426
Ficha técnica
- Tiempo de entrega
- 3–5 días hábiles
- Material
- Impresión FDM en filamento
- Personalizable
- No
Reseñas
Aún no hay reseñas de esta figura. Sé el primero — cada pieza se imprime a pedido en Colombia.
Preguntas frecuentes
¿Cuánto cuesta la figura Wind Turbine?
La figura Wind Turbine cuesta $ 30.000 (COP), con IVA incluido cuando aplica.
¿En cuánto tiempo recibo la figura Wind Turbine?
Se imprime a pedido en 3 a 5 días hábiles tras confirmar el pago, más el tiempo de envío de la transportadora a tu ciudad en Colombia.
¿En qué material se imprime la figura Wind Turbine?
En filamento PLA mediante impresión 3D FDM: resistente, liviano y de origen renovable.
¿Hacen envíos de la figura Wind Turbine a toda Colombia?
Sí, despachamos a todo el país por transportadora con número de guía para rastrear tu pedido.
